Knowledge and recognition of vibration patterns linked to the source of origin in a monitored machine are the main topics. For each machine part the course units start with considerations regarding construction, repetitive motion and possible defects. The calculation of specific frequencies, which then take effect in the configuration, are based on these previous thoughts. After measurements are taken on the available machine parts, analysis follows, where the specific frequencies and patterns caused by the machine part are identified and categorised. Potential recommended actions are discussed.

- Analysis methods
- Phase and phase measurement
- Machine parts: (Shaft, coupling, pump, fan, Bearing, E-machine Belt drives, gear boxes)
- Resonance and non-specific damage patterns

Engineers, technicians, production foremen and shop floor personnel, maintenance and customer service

Lifetime Solutions - Monitoring Solutions

Participation in "Detector III with Trendline - Advanced Training" or "SmartCheck - Advanced Training" required.

2 Days

Further dates in DE / EN upon request.