Machine diagnosis with SmartCheck and Detector III - Advanced Live Training - Date on request
Training objective
Knowledge and recognition of vibration patterns linked to the source of origin in a monitored machine are the main topics. For each machine part the course units start with considerations regarding construction, repetitive motion and possible defects. The calculation of specific frequencies, which then take effect in the configuration, are based on these previous thoughts. After measurements are taken on the available machine parts, analysis follows, where the specific frequencies and patterns caused by the machine part are identified and categorised. Potential recommended actions are discussed.
Content of training
Analysis methods
Phase and phase measurement
Machine parts: (Shaft, coupling, pump, fan, Bearing, E-machine Belt drives, gear boxes)
Resonance and non-specific damage patterns
Phase and phase measurement
Machine parts: (Shaft, coupling, pump, fan, Bearing, E-machine Belt drives, gear boxes)
Resonance and non-specific damage patterns
Target audience
Engineers, technicians, production foremen and shop floor personnel, maintenance and customer service
Category
Maintenance Product and Services - Condition Monitoring Solutions
Training requirements
Participation in "Detector III with Trendline - Advanced Training" or "SmartCheck - Advanced Training" required.
Training duration
2 Days
Further information
Further dates in DE / EN upon request.